User Manual

23
  Step 12
Thread a rigging coupler into one of the 4-40 ball ends.
Slide a crimp onto the cable, then pass the cable through
the rigging coupler. The cable then goes back through
the crimp. Use a crimping tool or vice grips to secure the
crimp to the cable.
  Step 13
Repeat Steps 11 and 12 to prepare the other end of
the cable.
 Step 14
Attach the ball ends to the servo horn using the hardware
included with the ball ends.
 Step 15
Install the rudder servo into the fuselage and attach the
servo horn to the servo using the hardware provided
with the servo. The output of the servo faces the front of
the fuselage. Note that the cables cross once inside the
fuselage: The cable from the right side of the servo exits
the left of the fuselage and vice versa.
 Step 16
Place light tension on the cable and align it so it is
centered in the exit opening. The rudder control horn
centerline should be 7/8-inch (22mm) from the bottom of
the rudder. Mark the rudder where the cable crosses with a
felt-tipped pen.
Radio Installation