User Manual

25
 Step 20
Connect the rudder tiller bracket to the tailwheel steering
arm using the two rudder springs. You will need to bend
the springs to attach them on each end using pliers.
 Step 21
Wrap the receiver battery and receiver in 1/4-inch (6mm)
foam. Attach the receiver and receiver battery to the radio
tray using hook and loop straps.
 Step 22
Slide the radio tray into the fuselage and secure its
position using two #2 x 1/2-inch sheet metal screws.
 Step 23
Install a choke ring (JRPA029) on each of the the
18-inch (457mm) aileron extensions that are plugged
into the receiver. These will be hidden under the radio
tray. This is strongly recommended due to all the metal
struts on the Cub.
 Step 24
Plug two 18-inch (457mm) servo extensions into
the receiver and route them through the holes in the
sides of the fuselage and up to the top of the fuselage.
Slide the radio tray cover into position so it locks into
position under the rear cabin wall. Use two #2 x 1/2-inch
sheet metal screws to secure the radio tray cover inside
the fuselage.
Radio Installation