User Manual

28
 Step 8
Thread a 1-inch (25mm) threaded rod into each end of
the throttle pushrod. Thread a metal clevis onto one of
the threaded rods and slide the pushrod into the pushrod
tube. Attach the clevis to the arm of the carburetor.
 Step 9
Secure the throttle servo in the fuselage using the
hardware provided with the servo. Thread a clevis onto the
threaded rod and attach the clevis to the servo arm.
 Step 10
Check the operation of the throttle servo to make sure
it doesn't bind and the throttle will move from open to
closed. Make any adjustment at this time to the throttle
linkage as necessary.
 Step 11
Slide the fuel tank into the fuselage with the stopper facing
toward the top of the fuselage. Use a rubber band to keep
the fuel tank from moving rearward in the fuselage.
 Step 12
Use two #2 x 1/2-inch sheet metal screws to secure the
battery cover in position behind the fuel tank.
Engine Installation (Glow)