User Manual

30
Required Parts
• Fuselage assembly • Firewall template
• Throttle pushrod tube • Metal clevis (2)
• Battery cover • #4 washer (4)
• Cowl screw tubing (4) • Throttle pushrod
• Fender washer (4)
• Ignition switch (JRPA004)
• 10-32 x 5/8-inch bolt (4)
• 4-40 x 1/2-inch socket head screw (4)
• #2 x 1/2-inch sheet metal screw (2)
• Threaded rod, 1-inch (25mm) (2)
• 38mm engine stand-offs (EVO3307)
Required Tools and Adhesives
• Drill
• Clamp • Medium CA
• Phillips screwdriver • Threadlock
• Hex wrench: 3/32-inch, 9/64-inch
• Drill bit: 1/16-inch (1.5mm), 3/16-inch (4.5mm)
 Step 1
Place the firewall template in position on the firewall. Drill
the locations for your particular engine using a 1/16-inch
(1.5mm) drill bit. Drill the location for the throttle pushrod
at this time as well.
 Step 2
Remove the template and enlarge the holes using a
3/16-inch (4.5mm) drill bit.
 Step 3
Slide the throttle pushrod tube into the hole drilled in
the firewall. The tube will extend forward of the firewall
slightly. Use medium CA to glue the tube to the firewall.
 Step 4
Attach the engine and accessories to the firewall as shown
in the following photos.
Engine Installation (Gas)