User Manual

Required Parts

• Wing (left and right) • Short strut pin (4)

• Mid-span stud (4) • 4mm nut (4)

• Wing strut end (4) • Long strut pin (4)

• Retainer clip (8) • Aluminum wing tube

• Wing strut wing bracket • 4-40 locknut (8)

• 1/4-20 nylon wing bolt (2)

• Mid-span cross brace (2)

• 4-40 x 3/4-inch socket head screw (8)

• 4-40 x 3/8-inch socket head screw (4)

• 4-40 x 1/2-inch socket head screw (4)

• Front wing strut (left and right)

• Rear wing strut (left and right)

Required Tools and Adhesives

• Hex wrench: 3/32-inch • Threadlock

• Nut driver: 1/4-inch

  Step 1

Attach the wing strut wing brackets to the bottom of the

wing using four 4-40 x 3/4-inch socket head screws.

Note: Use threadlock on the screws to

prevent them from vibrating loose in flight.

  Step 2

Thread two of the mid-span studs into the wing. The

threads of the studs should be flush to the top of the wing

  Step 3

Attach the front and rear wing strut to the brackets

using four 4-40 x 1/2-inch socket head screws and

4-40 locknuts.

Note: The wide strut goes toward the leading

edge, the narrow strut toward the trailing

edge. The airfoil on the struts will match

the wing as well when they are installed.

Wing Installation