User Manual

37
  Step 4
Thread the wing strut ends and 4mm nuts on the ends
of the struts.
  Step 5
Install the mid-span supports and cross brace as shown.
The brace and supports attach using two 4-40 x 3/8-inch
socket head screws and 4-40 locknuts. The supports
attach to the mid-span studs using two long strut pins and
two retainer clips.
  Step 6
Slide the aluminum wing tube into the fuselage. The wing
is then slid onto the wing tube. Plug the servo lead in the
wing into the extension inside the fuselage.
  Step 7
The wing is held in place using a 1/4-20 nylon wing bolt.
Wing Installation