User Manual
38
Step 8
Confirm that there is a piece of tubing on the pin before
inserting it into the brace. If not, install a piece of tubing
to prevent vibration and radio interferrence. Slide the
short pins from the strut ends into the brace at the
fuselage. It will be necessary to adjust the strut ends
to align without binding or twisting the wing. Once
adjusted, tighten the 4mm nuts against the ends to
prevent them from changing position.
Note: Use threadlock on the strut
ends and 4mm nuts to prevent them
from vibrating loose in flight.
Step 9
Secure the strut ends to the wing using two retainer
pin clips.
Wing Installation