User Manual

8
Required Parts
• Stabilizer (2) • Elevator (2)
• Wing (left and right) • Rudder
• Aileron (left and right) • Fuselage
• CA hinge (19)
Required Tools and Adhesives
• Rotary tool • T-pins
• Thin CA
• Drill bit: 1/16-inch (1.5mm)
   Step 1
Use a rotary tool and 1/16-inch (1.5mm) drill bit to drill a
hole in the center of each of the three hinge slots in both
of the stabilizers.
Note: While your rotary tool is out,
drill the holes in the elevators, ailerons,
wing, rudder and fin as well.
   Step 2
Place a T-pin in the center of three CA hinges.
   Step 3
Position the hinge in the stabilizer. The slot in the hinge
will align with the hole drilled in the stabilizer.
   Step 4
Slide the hinges in the elevator. Position the stabilizer
and elevator so there is as little gap between the two as
possible without restricting movement. Align the tips of
the stabilizer and elevator.
Hinging the Control Surfaces