User Manual

9
   Step 5
Apply thin CA to the top and bottom of each of the three
hinges. Make sure to saturate each hinge so there is
enough CA to wick into the hinge and bond with the
surrounding wood.
Note: Do not use CA accelerator on the
hinges. The CA must be allowed to wick
fully into the hinge to provide the best bond
between the hinge and the surrounding wood.
   Step 6
Allow the CA plenty of time to cure. Once cured, pull on
the elevator and stabilizer to make sure the hinges are
fully glued into position.
   Step 7
Flex the elevator up and down a number of times to break
in the hinges.
Hinging the Control Surfaces