Manual

27
 Step 4
Position the engine on the mount so the drive washer is 6
inches (152mm) forward of the firewall. Clamp the engine
to the mount and transfer the locations for the engine
mounting bolts onto the engine mounts.
 Step 5
Drill the locations for the engine mounting screws using a
drill and 5/32-inch (4mm) drill bit.
 Step 6
Slide the throttle pushrod tube into the hole drilled in
the firewall. The tube will extend forward of the firewall
slightly. Use medium CA to glue the tube to the firewall.
Note: It may be necessary to rotate
the carburetor to align with the throttle
pushrod tube. Check the alignment before
attaching the engine to the engine mount.
 Step 7
Use four 8-32 x 1
1
/
2
-inch socket head screws, four
8-32 locknuts and eight #8 washers to secure the engine
to the mount.
Engine Installation (Glow)