User Manual

11
    Step 13
Fully deflect the aileron in the up position. Place the
straight edge over the hinge line covering that you just
ironed down in Step 2 with the edge of the straight edge
placed firmly at the bottom of the hinge line as shown.
Iron down this side of the covering, making sure the
aileron is fully deflected.
 Step 14
Repeat Steps 11 through 13 for the remaining aileron
hinge gap.
 Step 15
Repeat Steps 11 through 13 for both elevator halves using
a 1" x 15" (13mm x 380mm) piece of clear covering.
Section 2 – Aileron Servo Installation
Required Parts
• 8-32 flange nut (2) • 4-40 lock nut (2)
• Ball link for swivel link (2) • Molded swivel link (2)
• Wing panel (right and left)
• 8-32 x 2
1
/
4
" control horn screw (2)
• 4-40 x 1/2" socket head screw (2)
• Ball link for servo arm (2)
• 4
1
/
4
" aileron linkage (2)
Required Tools and Adhesives
• Drill • Ruler
• Drill bit: 1/16" (1.5mm)
• Phillips screwdriver (small)
• 18" Servo Extension (JRPA099) (2)
• 3D 1/2 Servo Arm 4-40: JR (HAN3578) (2)
  Step 1
Install the servo hardware (grommets and eyelets)
included with the servo. Plug a 18" servo extension
onto the servo. Tie the servo leads together, using a
commercially available connector, or use unwaxed dental
floss to secure the extensions to prevent them from
coming loose during flight.
Section 1 – Hinging the Control Surfaces