User Manual

12
  Step 2
Tie the string to the servo extension and insert the servo
into the wing. Use the string to pull the servo lead through
the wing. Position the servo so the output shaft is toward
the trailing edge of the wing. Use a 1/16" (1.5mm) drill
bit to drill the locations for the servo screws. Mount the
servos using the hardware provided with the servos.
  Step 3
Mix a small amount of 30-minute epoxy and lightly coat
the inside of the hole in the aileron and the 8-32 x 2
1
/
4
"
control horn screw. Thread the screw into the hole from
the top of the surface. Wipe away any excess epoxy on the
wing and screw with rubbing alcohol and a paper towel.
Screw the 8-32 flanged nut in place as shown. Allow the
epoxy to fully cure.
  Step 4
Screw the molded swivel link onto the 8-32 screw until
the distance from the aileron surface to the top of the link
is 1
1
/
8
" (28.6mm).
Section 2 – Aileron Servo Installation