User Manual

13
  Step 5
Using the 4-40 screws (don’t substitute a standard screw)
and nuts included, attach the ball link to the outer hole
in the servo arm from the bottom side as shown. The
sequence is screw, ball link, servo arm and nut. Don’t
forget to use threadlock.
Note: Hangar 9® aluminum servo arms
are suggested for ease of installation and
durability. Use 3D 1/2 Servo Arm 4-40:
JR (HAN3578) for the aileron servos.
  Step 6
Screw a 4-40 ball link 5 to 6 turns onto each end of a
4
1
/
4
" long aileron linkage.
  Step 7
Center the servo using the radio system. Attach the servo
horn to the servo using the screw provided with the servo.
The arm faces towards the root of the wing.
  Step 8
Attach the linkage to the servo horn on the aileron.
Adjust the link so the aileron is centered at the same
time as the servo.
 Step 9
Repeat Steps 1 through 8 for the remaining wing panel.
Section 2 – Aileron Servo Installation