User Manual
15
Step 5
Slide the aluminum rod and tube into the holes in the
fuselage for the stabilizer. Slide one stabilizer onto the
rod and tube.
Step 6
Secure the stabilizer using two 3mm washers and two
3mm x 15mm machine screws. Use threadlock on the
screws to prevent them from loosening during flight.
Step 7
Repeat Step 6 to secure the remaining stabilizer to
the fuselage.
Step 8
Test fit the rudder assembly to the fuselage. Remove
any covering from the fin post that comes in contact
with the fuselage. Use 30-minute epoxy to glue the fin
to the fuselage.
Section 3 – Wing and Tail Installation