User Manual

Section 7 – Tail Wheel Installation

Required Parts

• Fuselage • Tail wheel assembly

• Tail wheel spring (2) • Tiller arm

•#4 x 5/8" socket head wood screw (3)

Required Tools and Adhesives

• Drill • Felt-tipped pen

• Drill bit: 5/64" (2mm)

 Step 1

Secure the tiller arm to the bottom of the rudder using

three wood screws. Remove the screws and apply

2-3 drops of thin CA into the holes to harden the balsa,

and then reinstall the screws.

 Step 2

Position the tail wheel assembly in place as shown,

centered on the rear of the fuselage. Using a felt-tipped

pen, mark the positions for the mounting screws through

the tail wheel bracket.

 Step 3

Remove the bracket and drill 5/64" (2mm) pilot holes at

the previously marked positions. Use two #4 x 5/8" sheet

metal screws to secure the tail wheel bracket in place. A

hardwood plate is positioned in the rear of the fuselage,

allowing these screws to be firmly tightened.

Hint: Remove the screws and wick thin

CA into the holes to strengthen the

threads. When dry, reinstall the screws.

 Step 4

Use the tail wheel springs to make the connection between

the tiller arm and the steering arm. Bend the springs so

they won’t come loose during flight.