User Manual

28
 Step 15
Attach the cowling onto the fuselage using four
4-40 x 1" socket head screws, four #4 washers and
four pieces of 1/4" (6mm) long fuel tubing. Make any
necessary cut-outs to clear items such as needle valves,
glow plugs, cut-off switches, mufflers, etc.
Note: Start by removing only a little
material at a time. You can always make
the holes bigger as you work. Work until
the cowl fits nicely over the engine.
 Step 16
Remove the bottom rear edge of the cowl for an air
exhaust. This is important for engine cooling.
 Step 17
Install the propeller and spinner to complete the
cowling installation.
Section 9 – Final Assembly
 Step 1
Wrap the receiver battery and receiver in 1/4" (6mm)
foam. Use Velcro straps or tie wraps to secure the receiver
and battery to the battery tray.
Required Parts
• Fuselage • Pushrod keeper
• Hatch • Canopy
• 4-40 x 1/2" screw (4) •#4 washer (4)
• Decals • 25–30% pilot
Required Tools and Adhesives
• Velcro straps • 1/4" (6mm) foam
• Hex wrench: 3/32" • Masking tape
• Formula 560-canopy glue • Shoo Goo
Section 8 – Engine Installation