User Manual

29
 Step 2
Mount the receiver switch in a convenient location in the
side of the fuselage.
 Step 3
Plug the servos into the receiver. Check the operation
of the servos using the transmitter. Make any necessary
programming changes to the radio for the operation of the
aileron and elevator servos.
 Step 4
Cut out the instrument panel decal from the decal sheet.
Attach it into position.
 Step 5
Install a 25% or 30% pilot figure to the hatch using
Shoo Goo or similar adhesive that will remain flexible.
Let the glue dry before securing the canopy in place.
 Step 6
Use hobby scissors to trim the canopy. Position the
canopy onto the canopy hatch. Trace around the canopy
and onto the hatch using a felt-tipped pen.
 Step 7
Lightly sand the inside edge of the canopy and
slightly inside the line drawn on the hatch using
medium sandpaper.
 Step 8
Apply a bead of RCZ56 Canopy Glue (ZINJ5007) around
the inside edge of the canopy. Position the canopy onto
the hatch. Use tape to hold the canopy secure until the
glue fully cures.
 Step 9
Apply the decals using the photos on the box as a guide.
Section 9 – Final Assembly