User Manual

Section 12 – Receiver, Battery and Fuel Tank

Installation

Required Parts

• Fuselage

Required Tools and Adhesives

• 1/8" light plywood • Velcro straps

• 6-minute epoxy

Step 1

Use foam and rubber bands (or Velcro® straps) to

secure the receiver to the battery tray.

Note: We have also mounted MatchBoxes

for the rudder and elevator servos next

to the receiver.

Step 2

If using the Zenoah® GT80, it will be necessary to

mount the battery pack slightly near the wing’s

trailing edge to properly balance the model. The

lighter weight Zenoah G62 requires that the battery

be mounted in the nose.

Step 3

Wrap the receiver battery in foam and use rubber

bands or Velcro straps to secure the battery to the

battery tray. Use 6-minute epoxy to attach the battery

tray in the fuselage in the correct location for your

engine selection.

Step 4

Assemble the tank per the instructions included with

the tank. Be sure to use the gas-compatible stopper

and fuel tubing.

Step 5

Place foam on the floor of the tank compartment.

Secure the tank in place by wrapping rubber bands

or Velcro straps around the tank and tank floor. Cup

hooks can be used to hook the rubber bands to the

tank floor. Later we will run the fuel lines.

Step 6

Mount the receiver switch in a convenient location in

the side of the fuselage.