User Manual

30
Section 14 – Hatch Assembly
Required Parts
• Hatch • Canopy
• 4-40 x 1/2" screw (4) • #4 washer (4)
• Decals • 1/3-scale pilot
Required Tools and Adhesives
• Hex wrench: 3/32" • Formula 560-canopy glue
• Shoo Goo • Masking tape
Step 1
The Edge hatch comes pre-installed on the
fuselage and is held on with two 4-40 socket head
cap screws. Remove these and lift the hatch from
the fuselage.
Step 2
Cut out the instrument panel decal from the decal
sheet. Attach it to the hatch as shown.
Step 3
Install a 1/3-scale pilot figure to the hatch using
Shoo Goo or similar adhesive that will remain
flexible. Let the glue dry before securing the
canopy in place.
Step 4
Position the canopy onto the canopy hatch. Trace
around the canopy and onto the hatch using a
felt-tipped pen.