User Manual

Step 5

Lightly sand the inside edge of the canopy and

slightly inside the line drawn on the hatch using

medium sandpaper.

Step 6

Apply a bead of RCZ56 Canopy Glue (ZINJ5007)

around the inside edge of the canopy. Position the

canopy onto the hatch. Use tape to hold the canopy

secure until the glue fully cures.

Step 7

Apply the decals using the photos on the box

as a guide.

Section 15 – Balancing the Model

Correctly balancing an aerobatic model is critical to

its performance and flight characteristics. Checking

the balance on giant-scale models is best done with

two people.

Step 1

Measure back 6"–6

" from the leading edge at the

wing tip and mark the CG range with a felt-tipped

pen. This is the recommended center of gravity (CG)

range.

Step 2

Fully assemble the model. With a helper, lift the

airplane with your index fingers to find the balance

point. The balance point (CG) should lie between

the two marks on the wing. If not, add the necessary

weight to the nose or tail to obtain

the correct balance.