User Manual

Section 11: Installing the Radio

Parts Needed

• Fuselage assembly

• Receiver

• Receiver battery

• Standard servos (3)

• RC foam

• 12" servo lead

Tools and Adhesives Needed

• Phillips screwdriver

• Hobby knife w/#11 blade

• Drill

• Drill Bit: 1/16"

Step 1

Install the mounting hardware (rubber grommets and brass eyelets)

supplied with your radio system on to the elevator, rudder and

throttle servos.

Step 2

Mount the servos into the servo tray of the fuselage as shown. Secure

the servos with the mounting screws provided with your radio system.

Step 3

Mount the battery switch to the left side of the fuselage as shown.

Step 4

Using RC foam, cut three layers of foam the size of the receiver

compartment (approximately 4

/2" by 3

/4"). Trace the outline of

your receiver and receiver battery pack onto one layer and cut

them out using a sharp hobby knife.

Step 5

Place one layer of foam in the fuselage and then the cut layer.

Connect the servos to the receiver in the appropriate channel.

Also connect a 12" servo lead into the aileron channel, this will

allow easy removal and installation on the wing. Run the receiver

antenna down the tube installed in the right side of the fuselage.