User Manual

27
Section 12: Installing the Rudder,
Elevator and Throttle Linkage
Parts Needed
• Fuselage assembly
• Nylon clevis w/clevis keepers (3)
• L-bend keepers (3)
• Easy connector
• Control wires (4)
- 28
3
/4" threaded on one end ............ Elevator
- 25
1
/2" threaded on one end ............ Rudder
- 20" threaded on one end ................ Throttle
- 17
3
/4" no threads ............................ Nose wheel steering
Tools and Adhesives Needed
• Pliers
• Side cutters
• Z-bend pliers
• Phillips screwdriver
• Felt-tipped pen/pencil
Step 1
Locate the three control wires threaded on one end and three
nylon clevises with clevis keepers. Thread a clevis onto the
threaded end of each control wire with the keeper in place as
shown. Thread each clevis on a minimum of 12 turns.
Step 2
Looking at the rear of the fuselage locate the pre-installed elevator
control wire tube. Slide the elevator control wire (28
3
/4") through
the tube and connect the clevis to the elevator control horn.
Step 3
With the elevator at the neutral position and the elevator servo
centered, mark the control wire where it crosses the outer hole of
the servo arm.