User Manual

Section 1: Hinging the Ailerons

Parts Needed

• Right wing panel w/aileron

• Left wing panel w/aileron

• CA hinges (8)

Tools and Adhesives Needed

• Thin CA

• CA remover/debonder

• 6-minute epoxy

• Masking tape

• T-pins

• Rubbing alcohol

• Paper towels

Note: The photos and instructions in this section are for

the right wing panel. Repeat the same steps to hinge the

aileron on the left wing panel.

Step 1

Locate the right wing panel and remove the aileron. Note that the

leading edge of the aileron has a hole at one end that slides onto

the aileron torque rod already installed in the wing panel.

Step 2

Locate the CA hinges required for the aileron. Place a T-pin in the

center of each hinge and slide them into the precut hinge slots of

the wings trailing edge as shown.

Step 3

Trial ﬁt the aileron to the wing; make sure there is no more than

1/32" gap along the hinge line. Once satisﬁed with the ﬁt, remove

the aileron.

Step 4

Mix approximately 1/4 ounce of 6-minute epoxy. Using a tooth-

pick, apply the epoxy to the inside of the hole in the aileron. Slide

the aileron onto the torque rod and hinges, being careful not to

get any epoxy into the torque rod tube. Wipe away any excess

epoxy with rubbing alcohol and paper towels. Remove the T-pins

and push the aileron completely against the wing trailing edge.

Use masking tape to hold the aileron in place until the epoxy

completely cures.