User Manual

Section 3: Installing the Aileron Servo Tray

Parts Needed

• Completed wing

• Plywood servo tray

• Wood servo rails

• Aileron servo w/mounting hardware

Tools and Adhesives Needed

• 6-minute epoxy

• Thick CA

• Hobby knife

Step 1

Locate the servo tray and two servo mount rails (3/8"x 2"). Using

thick CA, glue the servo rails to the servo tray as shown. The

beveled edge of the rails should form a “V” to allow the tray to

mount to the bottom of the wing. Allow the CA to dry.

Step 2

Install the mounting hardware (rubber grommets and brass eyelets)

supplied with your radio system on to the aileron servo.

Temporarily install the aileron servo on the servo tray as shown

and test ﬁt the entire assembly to the wing. Make sure the servo

output shaft is oriented towards the trailing edge of the wing.

Note: It may be necessary to trim away some of the sheeting

on the bottom of the wing to allow the servo to slide down

into the opening. Using a sharp hobby knife, carefully

trim only a small amount at a time.