User Manual

16
 Step 5
Connect the clevises from the aileron pushrods to the
aileron control horns. The alignment of the ailerons will be
checked later in this manual.
Required Parts
• Wing panel (left and right) • Wing tube
• Covering (white) • Covering (orange)
Required Tools and Adhesives
• 30-minute epoxy • Mixing cup
• Mixing stick • Epoxy brush
• Rubbing alcohol • Paper towel
• Painter's tape • Covering iron
Note: It is not necessary to glue the wing
panels together on your model. This section
has been provided in case you opt to do
so. Make sure your vehicle has enough
room to transport the joined wing before
joining the wing panels using this method.
 Step 1
Slide the wing tube into the wing panel as shown. The
wing tube will only slide in halfway, so do not force it in
any further than it will slide easily.
Section 5: Wing Assembly
Section 5b: Optional: Gluing the Wing Halves
12843.1_HAN_Alpha40_SpektrumManual.indd 16 6/4/10 10:18:10 AM