User Manual

Section 9: Engine Installation
24
Required Parts
• 8-32 x 1
1
/
2
” bolt (4) • 8-32 x 1” bolt (4)
• 8-32 locknut (4) • #8 washer (8)
• Engine mount
Required Tools and Adhesives
• Phillips screwdriver • Threadlock
• 2
1
/
2
" spinner (white) • Ruler
Step 1
Position the engine mount on the firewall. Use four
8-32 x 1" screws and four #8 washers to attach the
mount to the firewall. Make sure to use threadlock
on the screws to prevent them from loosening during
flight.
Step 2
Slide the engine into position onto the mount as
shown. Position the engine on the mount so the drive
washer is 4
3
/
4
" in front of the firewall.
Step 3
Use a felt-tipped marker to mark the locations for the
engine mounting bolts.
Step 4
Drill four 3/16" holes at the locations marked in the
previous step. It is suggested to use a drill press for
the best results.