User Manual

Step 5. Attach the control horn to the aileron using the screws

and the control horn backplate. Be careful not to accidentally

puncture the covering with the screwdriver.

Step 6. With the linkage attached to the control horn, center

the control surface and hold the linkage wire directly over the

electronically centered servo arm. Place a mark on the rod

directly over the hole (second hole from the end of arm) in

servo control arm that it will connect to.

Step 7. Make an L-bend in the rod at the location you just marked.

Step 8. Insert the L-bend through the second hole from the end

of the servo arm. Mount wire keeper to retain wire on the servo

arm. Install the clevis back onto the control horn. Be sure to slide

on the silicon clevis keeper onto the end of the clevis.

Step 9. Repeat the process for the other aileron linkage.