User Manual

Step 5. Repeat the preceding process for the other elevator half.

Step 6. Measure 1/2" from the bottom of the left side of the

rudder. Mark the location with a felt-tipped pen or pencil. This

mark will serve as the center for the rudder control horn.

Step 7. Center the control horn over the mark you’ve just made.

Make sure the horn is positioned over the hinge line, just like

you did for the elevator. Using a felt-tipped pen or pencil, mark

the mounting hole locations onto the rudder.

Step 8. Drill these holes with a 1/16" drill bit and install the

rudder control horn, using the screws and backplate provided.