User Manual

Parts Needed

• Main landing gear (2 pieces)

• Fuselage

• Landing gear axles with lock nuts (2)

• Wheel collar with screw (2)

• Landing gear bolts (6)

• Washers

Tools and Adhesives Needed

• Felt-tipped pen or pencil

• Hobby knife

• Round file

• Drill

• Drill Bit: 5/32"

• Phillips screwdriver

• Threadlock

Note: The main landing gear is made up of two landing

gear sections. Instructions for mounting the wheel pants

will be provided in Section 11.

Step 1. Attach the axles to the aluminum landing gear using the

lock nuts provided. The wheels will be mounted when the wheel

pants are installed.

Note: It’s always a good idea to use threadlock on the

wheel collar bolts to keep them from coming loose.

Step 2. Locate the six predrilled mounting holes in the bottom

of the fuselage for mounting the landing gear. The blind nuts are

preinstalled from inside the fuselage. If the covering is over the

holes, use a sharp hobby knife and carefully remove the covering

over the pre-drilled holes.

Step 3. Bolt the landing gear onto the fuselage with the

included hardware. Take a bolt and washer and insert it

through the aluminum landing gear and holes in hatch.

Thread the mounting bolts into the preinstalled blind nuts

and securely tighten.

Note: It’s a good idea to use threadlock on bolt/nuts.

Section 10: Installing the Main Landing Gear