User Manual

Engine Requirements
• .40–.48 2-cycle engines
• .56–.72 4-cycle engines
Recommended 2-Cycle Engines
• MDS
™
.40 FS Pro
• MDS .48 FS Pro
• MDS .58 FS Pro
Recommended 4-Cycle Engine
• Saito
™
.56 or .72
Parts Needed (not included in kit)
• Aileron Extension (6") (2)(JRPA094)
• Propeller (refer to engine operating instructions for proper size of propeller to use)
• Foam for cushioning the fuel tank and radio
• Fuel tubing (12")
•2
1
/
4
" Spinner
4
MDS .48
Tools and Supplies Needed (not included in kit)
Adhesives
• Thin CA (cyanoacrylate) glue
• CA remover/debonder
• 6-minute epoxy
• 30-minuet epoxy
• Pacer Z-42 Threadlock
• Canopy glue (RC-56)
Tools
• Rubbing alcohol
• Epoxy brushes
• Paper towels
• Drill
• Drill Bits: 1/16", 1/8", 1/4"
• Phillips screwdriver
• Z-bend pliers
• Needle-nose pliers
• Standard pliers (optional)
• Hobby knife with #11 blade
• Mixing sticks for epoxy
• 90-degree triangle
• Medium grit sandpaper
• Masking tape (3M blue recommended)
• Straight edge
• Measuring device (e.g., ruler, tape measure)
• Scissors
• Wax paper
• Felt-tipped pen or pencil
• T-pins
• Toothpicks
• Moto-tool with cutting wheel
• Saw blade (#27 Excell recommended)
• Antenna tube (optional)
Saito .72