User Manual

Parts Needed

• 4-channel radio system with 5 servos and hardware

(not included)

• Radio-packing foam (not included)

• Antenna tube (optional, not included)

Tools and Adhesives Needed

• Drill

• Drill Bit: 1/16"

• Phillips screwdriver

• Hobby knife with #11 blade

• Felt-tipped pen or pencil

Step 1. Locate grommets and eyelets for the servos and mount

per the instructions included with the radio.

Step 2. Locate the plywood servo tray mounted in the fuselage.

Trial fit the servos in place, with the rudder and elevator servos

in place along the sides of the fuselage, and the throttle servo

toward the front of the fuselage in the direction of the fuel tank.

Note the orientation of the servo arms.

Step 3. Once you are satisfied with the servo’s location,

use a felt-tipped pen or pencil to mark the mounting holes for

all three servos.

Step 4. Remove the servos and drill 12 holes using a 1/16"

drill bit. Remount the servos and screw in the mounting screws

provided with the servos.

Section 14: Installing the Radio