User Manual

Step 18. To install the throttle pushrod, locate the wire throttle

pushrod and make a Z-bend at one end. This will be used to

connect the carburator and to the throttle servo. Mount the

engine and locate the point where the throttle linkage must

exit the firewall to connect directly to the throttle arm on the

carburator. Mark this point.

Step 19. Remove the fuel tank so you do not accidentally drill

through it and drill a 1/8" hole in the firewall of the marked point.

Step 20. After drilling the hole in the firewall, slide the plastic

tubing through the hole and secure in place with CA. Insert the

wire throttle linkage into the nylon tube from the front of the

model and attach to the throttle arm.

Step 21. Install the EZ Connector onto the throttle servo arm.

Position the throttle servo at neutral position, set the carbrator

arm at 1/2 throttle, and tighten the EZ Connector.