User Manual
11
DeNight Special 50 ARF Assembly Manual
Step 16
Remove the T-pins and push the stabilizer and
elevator together to close the gap and fully seat
the joiner in the groove in the elevator. Use rubbing
alcohol on a paper towel to clean any excess epoxy
that squeezes out.
Step 17
Apply 3–4 drops of thin CA to each hinge. Do not use
accelerator, the glue needs to penetrate the hinge for
a complete bond.
Step 18
Perform steps 13 through 16 to install the opposite
elevator half. Remove the tape and waxed paper
pieces once the epoxy has cured.
Step 19
Slide the pre-hinged n and rudder into the slot in
the top of the fuselage. You may need to deect the
rudder to the left for the control horn to clear the
elevator. Make sure the n is seated all the way down
and forward.
Step 20
Use a felt-tipped pen to mark the n where it meets
the top of the fuselage along both the left and right-
hand sides.
Step 21
Remove the n and rudder. Use a new #11 blade in a
hobby knife to cut 1/8 inch inside the marked line and
behind the front of the tailpost on both sides. Remove
the covering.