User Manual

14
DeNight Special 50 ARF Assembly Manual
􀀀 Step 9
Set the elevator servo in place and feed the servo
lead through the same hole.
􀀀 Step 10
Tuck the servo leads into the next hole forward so
they don’t fall under the servo tray.
􀀀 􀀀 Step 11
Use the screws provided with the servos to secure
them to the servo tray with a #1 Phillips screwdriver.
􀀀 􀀀 Step 12
Insert the bent ends of the pushrods into the outer
hole in the rudder servo arm and the inner hole of the
elevator servo arm. Secure the pushrods to the servo
arms with snap keepers.
􀀀 􀀀 Step 13
Slide a silicone keeper onto the rudder pushrod where
it exits the rear fuselage then thread on a clevis. With
the servo centered, adjust the clevis so that the rudder
is aligned with the n when the clevis is attached
to the center hole in the control horn. Use a ruler
to check the alignment of the n and rudder. Once
adjusted, slide the silicone keeper over the clevis to
prevent it opening accidentally.