User Manual

15
DeNight Special 50 ARF Assembly Manual
􀀀 Step 14
Repeat step 13 to connect the elevator pushrod to the
outer hole of the elevator control horn.
Aileron Servo and Linkage
Installation
Parts Required
Wing panels (L & R) Servos with hardware(2)
Clevises (2) Silicone keepers (2)
Servo mounting blocks (4)
9-inch servo extension leads (2)
#2 x 3/8-inch woodscrews (8)
3-inch steel aileron pushrods (2)
Tools Required
Ruler Pencil
Thin CA #1 Phillips screwdriver
Mixing cups Mixing sticks
30-minute epoxy Felt-tipped pen
Dental oss Sidecutters
Pin vise 5/64-inch drill bit
1/16-inch drill bit
􀀀 􀀀 Step 1
Prepare two servos with grommets and bushings.
􀀀 􀀀 Step 2
Use a #1 Phillips screwdriver to remove the standard
4-way servo arm from a servo. Use your radio to
center the servo then, install a 180-degree servo arm.
Remove one arm with sidecutters. Prepare the second
servo with the arm on the opposite side.
􀀀 􀀀 Step 3
Use a 5/64-inch drill bit in a pin vise to enlarge the
outer hole in each servo arm. This provides a servo
arm length of 9/16 inch (14mm).