User Manual

19
DeNight Special 50 ARF Assembly Manual
􀀀 Step 2
Locate the countersunk machine screws in the
hardware provided with the motor. Apply a drop of
threadlock to the threads of each screw and use a #1
Phillips screwdriver to secure the mount to the motor.
􀀀 Step 3
Locate the rewall drilling template and set it in place
on the front of the rewall. Identify the holes marked
with a triangle for electric power mounting and pilot
drill the rewall with a 5/64-inch drill bit.
􀀀 Step 4
Remove the template and use a 13/64-inch drill bit to
enlarge the holes.
􀀀 Step 5
Use a hobby knife to cut loose the center portions of
each side of the motor box and remove them. Remove
the small section in the bulkhead on the right-hand
side of the motor box also.
􀀀 Step 6
Press the 8-32 blind nut into place in the back of the
rewall in the holes drilled in step 4. Slide an 8-32 x 2
1/4-inch screw into a standoff and use it to draw the
blind nuts into place with a #1 Phillips screwdriver.
􀀀 Step 7
Use a #1 Phillips screwdriver to attach the motor to
the rewall with four 8-32 x 2 1/4-inch machine screws
and four 1 7/8-inch (48mm) standoffs. The leads from
the motor should exit to the lower left. Apply a drop of
threadlock to each of the screws prior to installation.