User Manual

DeNight Special 50 ARF Assembly Manual

􀀀 Step 2

Temporarily install the tray in the fuselage by using

a 3/32-inch hex wrench to secure the tray to the

fuselage with a 4-40 x 1/2-inch Allen screw and #4

steel washer.

􀀀 Step 3

There are two plywood tabs that get glued inside the

motor box to hold the front of the battery tray down

in ight. Apply medium CA to one long edge of a tab

and glue it in place as shown. You may nd it easier to

install the tab by holding it with the blade of a hobby

knife. Install the second tab on the opposite side.

􀀀 Step 4

Place the battery on the tray with the leads exiting to

the rear. Slide a hook and loop strap through the slots

in the center of the tray to secure the battery.

Note: You may choose to add a strip of adhesive-

backed hook and loop tape (not included) between the

battery and tray for additional security.

􀀀 Step 5

Slide the battery and tray into the fuselage.

􀀀 Step 6

Use a 3/32-inch hex wrench to secure the tray to the

fuselage with the 4-40 x 1/2-inch Allen screw and #4

steel washer.