User Manual

24
DeNight Special 50 ARF Assembly Manual
Throttle Servo Installation
Parts Required
Fuselage Servo with hardware
Hook and loop strap EZ link
Radio
Tools Required
#1 Phillips screwdriver Pin vise
3/32-inch drill bit Needle-nose pliers
Thin CA Sidecutters
􀀀 Step 1
Slide the hook and loop strap through the slots in
the right-hand side of the radio tray ahead of the tail
servos. This is easier to do before the throttle servo is
installed in the tray.
􀀀 Step 2
Prepare the throtte servo with grommets and
bushings. Note that the bushings are installed from
the bottom of the mounting lugs.
􀀀 Step 3
Use a #1 Phillips screwdriver to remove the servo arm
from the servo. Remove three of the arms with
sidecutters leaving one long arm. Use a 3/32-inch drill
bit in a pin vise to enlarge the outer hole in the arm.
This will provide a servo arm length of 1/2 inch (13mm).
􀀀 Step 4
Insert the EZ link connector in the outer hole of the
servo arm. Use needle-nose pliers to press the button
keeper into place on the bottom of the arm.
􀀀 Step 5
Center the throttle servo with your radio and use a #1
Phillips screwdriver to reinstall the servo arm in the
position shown.