User Manual

25
DeNight Special 50 ARF Assembly Manual
􀀀 Step 6
Use a #1 Phillips screwdriver to thread a servo
mounting screw into each of the pre-drilled holes for
the throttle servo, then remove the screw.
􀀀 Step 7
Apply 1–2 drops of thin CA to each of the holes to
strengthen the wood. Allow the CA to cure without
using accelerator.
􀀀 Step 8
Feed the throttle servo lead into the servo opening
then under the tray to exit the same hole as the rudder
and elevator servo leads. Set the servo in place with
the output shaft towards the right-hand fuselage side
then use a #1 Phillips screwdriver to secure it using
the screws provided with the servo.
2-Stroke Engine Installation
Parts Required
Fuselage Engine
Engine mount Radio
#8 steel washers (4) 8-32 blind nuts (4)
#6 steel washers (4) 6-32 nylon locknuts (4)
Firewall template Nylon pushrod housing
Silicone keeper Nylon clevis
6-32 x 1-inch Allen head machine screws (4)
8-32 x 3/4-inch Allen head machine screws (4)
Long throttle pushrod plywood standoff
17-inch steel throttle pushrod
Tools Required
Ruler Pencil
Drill motor 1.5mm hex wrench
Drill bits: 5/64, 9/64, 11/64, 13/64, 5/32-inch
7/64-inch hex wrench 5/16-inch wrench
Threadlock Canopy glue
Medium CA #2 Phillips screwdriver
Rotary tool with cutoff wheel
􀀀 Step 1
Measure 11/16 inch in from the right-hand side of
the rewall and 13/16 inch up from the bottom of the
rewall. Make a mark with a pencil.