User Manual

26
DeNight Special 50 ARF Assembly Manual
􀀀 Step 2
Use an 11/64-inch drill bit in a drill motor to make a
hole at the marked location.
􀀀 Step 3
Use medium CA to glue a long throttle pushrod
standoff into the slot inside of the motor box on the
right-hand side ahead of the cutout.
􀀀 Step 4
Set the rewall template in place and use a 5/64-inch
drill bit to pilot drill the holes marked with circles for
the 2-stroke installation.
􀀀 Step 5
Remove the template and enlarge the holes with a
13/64-inch drill bit in a drill motor.
􀀀 Step 6
Place a #8 steel washer on each of the 8-32 x 3/4-
inch Phillips head machine screws. Insert the screws
into the mounting holes in the engine mounts.
􀀀 Step 7
Press an 8-32 blind nut into each hole from the back
of the rewall. Apply a drop of threadlock to the
threads of each engine mount screw and install the
mounts with a #2 Phillips screwdriver to draw the blind
nuts into place.