User Manual

29
DeNight Special 50 ARF Assembly Manual
􀀀 Step 2
Use a #1 Phillips screwdriver to remove the two
carburetor retaining screws on the rear of the engine.
Remove the carburetor and rotate it 180 degrees so
the needle valve is on the left-hand side. Reinstall the
screws to secure the carburetor.
􀀀 Step 3
Use a 5/64-inch drill bit in a pin vise to enlarge the
center hole in the carburetor throttle arm.
􀀀 Step 4
On the right-hand edge of the rewall, measure 1 5/8
inches (41mm) down from the top edge and make a
mark with a pencil.
􀀀 Step 5
Use an 11/64-inch drill bit in a drill motor to make a
hole for the throttle pushrod housing at the marked
location. Drill the hole as close as possible to the inner
side of the motor box.
􀀀 Step 6
Set the rewall template in place and use a 5/64-inch
drill bit to pilot drill the holes marked with circles for
the 4-stroke installation.
􀀀 Step 7
Remove the template and enlarge the holes with a
13/64-inch drill bit in a drill motor.