User Manual
33
DeNight Special 50 ARF Assembly Manual
Step 2
Identify the vent and feed lines in the fuel tank.
Make sure the pink fuel line on the right-hand side
is connected to the vent tube going to the top of the
tank. Slide the tank into the fuselage and pass the fuel
lines through the hole in the rewall then engage the
neck of the tank in the hole.
Step 3
Open the foam kit and locate the denser piece of foam
measuring 4 x 2 3/4 inches. Slide it underneath the
fuel tank.
Step 4
Use scissors to trim one of the 1/2-inch thick pieces
of foam to a length of 4 1/2 inches. Place the foam on
top of the fuel tank by inserting it through the opening
in the top of the motor box.
Step 5
Position the plywood tank retainer midway up the fuel
tank between the sides of the motor box. Glue it in
place with medium CA.
Step 6
Connect the pink vent line to the pressure nipple on
the mufer. If the line is excessively long, trim it as
necessary with sidecutters.
Step 7
Cut the green fuel feed line where it passes under the
needle valve assembly and insert the fuel tee from the
fuel dot package. Cut the removed portion of fuel line
to a length of 1 5/8 inches and use it to connect the
other side of the tee to the carburetor.