User Manual

34
DeNight Special 50 ARF Assembly Manual
􀀀 Step 8
Cut a 7 inch long piece of medium fuel tubing and
attach it to the tee tting. This will be the fuel tank ll
line and get routed to the fuel dot assembly.
􀀀 Step 9
Measure approximately 2 inches forward, and 1/2 inch
below the mounting hole in the right-hand side of the
cowling. Use a tapered reamer to make an 11/32-inch
diameter hole.
􀀀 Step 10
Slide the body of the fuel dot through the hole in the
cowling. Apply a small amount of threadlock inside the
cowling at the base of the threads, then thread on the
retaining nut to secure the fuel dot.
􀀀 Step 11
Measure approximately 2 inches forward, and 1/2 inch
below the mounting hole in the left-hand side of the
cowling. Use a tapered reamer to make a 7/32-inch
diameter hole.
􀀀 Step 12
Cut the cooling exit template from page 49 of the
manual. Use a hobby knife to remove the shaped
portion of the template and cut out the small hole.
􀀀 Step 13
Align the rear edge of the template with the lower rear
edge of the cowling and the hole in the template over
the cowl mounting hole. Tape the template in place
with low-tack tape and use a felt-tipped pen to mark
the cutout.