User Manual

4
DeNight Special 50 ARF Assembly Manual
Important Warranty Information
Please read our Warranty and Liability Limitations
section on page 46 before assembling this product. If
you as the purchaser are not prepared to accept the
liability associated with the use of this Product, you are
advised to return this Product immediately in new and
unused condition to the place of purchase.
Recommended Setup–2-Stroke Glow
● Evolution .52NX with mufer (EVOE0520)
● Evolution propeller 11x6 (EVO11060)
● Fuel dot ller (HAN115)
● Remote glow plug adapter (HAN3025)
● Exhaust deector (DUB697)
Recommended Setup–4-Stroke Glow
● Saito FA-82B (SAIE082B)
● Evolution propeller 13x8 (EVO13080)
● Mufer right angle adapter (SAI65140)
● Fuel dot ller (HAN115)
● Remote glow plug adapter (HAN3025)
● Exhaust deector (DUB697)
Recommended Setup–Electric Power
● E-ite Power 46 (EFLM4046A)
● E-ite 60-Amp Pro Switch-Mode BEC Brushless
ESC (EFLA1060)
● Thunder Power 3850mAh 4S 14.8V Pro Power 30C
Li-Po (THP38504SP30)
● APC Propeller 13x6.5E (APC13065E)
Transmitter Requirements
The DeNight Special requires a minimum of a 4-channel
radio to operate all the functions of your aircraft. We
suggest the following radio systems available through
Horizon Hobby or your local hobby distributor.
Spektrum DX6i SPM6600
Spektrum DX7 SPM2710
JR X9303 2.4GHz JRP2915
Radio Equipment Requirements -
7-Channel Receiver
The following items are recommended when installing
the 7-Channel AR7000 receiver (SPM6070) in your
aircraft:
DS821 Digital Sport Servo (5) JRPS821
(Note: One less servo required for EP version)
6-inch Servo Extension (1) (ESC) JSP98020
9-inch Servo Extension (4) (Ailerons) JRPA097
Receiver Battery, 6-volt, 2300mAh JRPB5006
JR Chargeswitch JRPA004
Ailerons: DS821 Servo (2)
● 9-inch Extension (plugged into receiver) (2)
● 9-inch Extension (connected to servo) (2)
Elevator: DS821 Servo
Rudder: DS821 Servo
Throttle: DS821 Servo
Note: ESC will require a 6-inch extension
plugged into the receiver
Field Equipment Required
● Fuel (15% recommended)
● Long Reach Glow Plug Wrench (HAN2510)
● Metered Glow Driver with Ni-Cd & Charger (HAN7101)
● 2-Cycle Sport Plug (EVOGP1)
● Manual Fuel Pump (HAN118)
Optional Field Equipment
● Self-stick weights, 6 oz (HAN3626)
● PowerPro 12V Starter (HAN161)
● 12V 7Ah Sealed Battery (HAN102)
● Power Panel (HAN106)
● Blue Block After Run Oil (EVOX1001)
● Cleaner and towels
Required Tools and Equipment
Drill motor Pin vise
Low-tack tape Needle-nose pliers
Ruler Sidecutters
File Felt-tipped pen
Pencil Coarse grit sandpaper
Tapered reamer Hobby knife w/ #11 blade
Dental oss Manila card stock
Alcohol Paper towels
Scissors Double-sided adhesive tape
Mixing sticks Mixing cups
Small cable ties T-pins
Toothpicks String
Phillips screwdriver: #1, #2
Rotary tool with cutoff wheel and sanding drum
Hex wrench: 3/32, 7/64-inch, 1.5mm, 2.5mm
Open-end wrench: 5/16-inch, 10, 12, 13mm
Drill bit: 3/64, 5/64, 3/32, 5/32, 9/64,
11/64, 13/64-inch
Required Adhesives
Thin CA (PAAPT08)
Medium CA (PAAPT02)
30-minute epoxy (PAAPT39)
Threadlock (PAAPT42)
Canopy glue (PAAPT56)
Other Required Items
Medium fuel tubing (DUB222)
Double-sided adhesive tape
Cable ties
The Spektrum trademark is used with
permission of Bachmann Industries, Inc.