User Manual

Note: Do not use CA accelerator during

the hinging process. The CA must be

allowed to soak into the hinge to provide

the best bond. Using accelerator will not

provide enough time for this process.

  Step 6

Remove the T-pins from the hinges. Deflect the

aileron and apply thin CA to each hinge. Make

sure the hinge is fully saturated with CA. Use a

paper towel and CA remover/debonder to clean up

any excess CA from the wing and/or aileron.

  Step 7

Firmly grasp the wing and aileron and gently pull

on the aileron to ensure the hinges are secure and

cannot be pulled apart. Use caution when gripping the

wing and aileron to avoid crushing the structure.

  Step 8

Move the aileron up and down several times to work

in the hinges and check for proper movement.

 Step 9

Repeat Steps 1 through 8 for the remaining aileron.

Section 3: Hinging the Ailerons