User Manual

18
Required Parts
• Fuselage assembly • Engine mount (2)
• 6-32 x 3/4" screw (4) • Fuel tank
• 16
3
/
8
" outer pushrod tube • 18
1
/
8
" pushrod wire
• Clevis w/retainer • Fuel tubing
• #6 x 5/8" socket head sheet metal screw (4)
Required Tools and Adhesives
• Masking tape • Drill
• Pliers • Clamp
• Engine • Medium CA
• Phillips screwdriver (large) • Sandpaper
• Drill bit: 3/32" (2.5mm), 5/32" (4mm)
• Foam: 1/4" (6mm), 1/2" (13mm)
 Step 1
Attach the engine mount to the firewall
using four 6-32 x 3/4" screws.
 Step 2
Position the engine on the mount. Adjust the engine
so the distance from the firewall to the drive washer is
4
1
/
2
" (114mm). Use a clamp to hold the engine in
position. Mark the locations for the engine mounting bolts.
Note: It may be necessary to remove
the carburetor from your engine and
rotate it so the needle valve faces
towards the top of the fuselage.
 Step 3
Remove the engine and drill the locations marked in
the previous step using a 3/32" (2.5mm) drill bit.
Cool Tip: Use a drill press for the best
results. This makes holes perfectly
perpendicular (square) to the mount.
Section 6: Engine Installation