User Manual

21
 Step 11
Remove the clevis from the pushrod. Slide
the pushrod into the pushrod tube from the
firewall. Attach the “Z” bend to throttle arm.
 Step 12
Thread the clevis onto the pushrod. Attach the clevis to
the throttle arm. Move the throttle to full throttle using the
radio. Check the carburetor to make sure it is fully open.
Adjust the clevis to correspond full throttle on the radio to
full throttle on the carburetor. Use the radio to check low
for idle and closed. Move the linkage at the carburetor arm
and servo arm as necessary for full range of operation.
 Step 13
Look at the side of the fuel tank to determine which
direction the vent line is facing. It will be installed
with the vent towards the top of the fuselage. Also
check which piece of tubing is connected to the vent
line. Install the fuel tank into the fuselage. Place
foam at any point where the fuel tank and fuselage
contact each other. Make any necessary supports
to keep the tank from moving during flight.
Cool Tip: Make sure the rear
support brace will not interfere with
the installation of the wing.
 Step 14
Install the muffler onto the engine, making sure it does not
interfere with the firewall. Make the proper connections to
the engine using the engine manufacturer’s instructions.
Section 6: Engine Installation