User Manual
8
Required Parts
• Wing • Fuselage
• 1/4-20 x 2" nylon bolt (2)
• Horizontal stabilizer • Elevator
• Carbon fiber tail support rods
Required Tools and Adhesives
• Thin CA • 30-minute epoxy
• Flat blade screwdriver • Sandpaper
• Drill bit: 1/16" (1.5mm) • Drill
• Felt-tipped pen • Square
• CA hinge (6) • Paper towel
• Rubbing alcohol • T-pin
• 6-minute epoxy
Step 1
Place the wing onto the fuselage. Secure the
wing using the 1/4-20 x 2" nylon bolts.
Step 2
Measure and mark a centerline on the
stabilizer using a felt-tipped pen.
Step 3
Locate six CA hinges. Place a T-pin
in the center of each hinge.
Section 1: Stabilizer Installation