User Manual

30EN
178. Fit the cross brace into the mount on the fl oat without
the rudder. Fit both the front and rear cross braces,
tightening the screws onto the fl at areas of the braces.
179. Slide the fl oat mounts on the struts. Tighten the screws
to secure the fl oats to the struts.
181. Use a hobby knife to cut a hole large enough to fi t the
servo lead from the fl oat into the fuselage. Use tape to
secure the lead to the rear strut.
 A small amount of silicone adhesive can be used to
seal the hole where the servo lead enters the fuselage.
180. Fit the fl oat with the rudder to the struts and cross
braces. Tighten the screws to secure the struts and
braces to the mounts.
182. Connect the lead from the fl oat to the receiver using
a 6-inch (150mm) servo lead. Connect the lead to
an unused channel and use programmable mixing to
operate the fl oat rudder.
 A “Y” harness can also be used to connect the
float rudder to the rudder channel of the receiver.
178.
179.
180.
181.
182.