User Manual

9Hangar 9 Taylorcraft 26cc BNF

 3. Separate the stabilizer halves. Slide the pins and one

stabilizer half into the holes in the fin as shown.

 4. Slide the remaining stabilizer half into position. Press the

stabilizer halves so they fit tightly against the fin as shown.

 5. Remove the packaging from the tail of the fuselage.

Place the assembly on the fuselage. The fin will fit into the

slot along the top of the fuselage.

Note: Always use threadlock on metal-to-metal

fasteners to prevent them from vibrating loose.

 6. Use four 6-32 x 1-inch button head cap screws and

four #6 washers to secure the stabilizer to the fuselage. Use

a 3/32-inch hex wrench to tighten the screws. Make sure

not to over-tighten the screws and damage the underlying

structure of the stabilizer.

Hint: A machined hex wrench is helpful to allow the

bolts to be tightened and not strip the head of the bolt.

Tail Wheel Installation

Required Parts

Fuselage assembly Aluminum tiller arm

3mm washer (2) Tail wheel steering spring (2)

Aluminum spreader tab

2mm x 15mm Phillips wood screw (2)

3mm x 15mm socket head wood screw (2)

Carbon fiber tail wheel assembly with

-inch (38mm)wheel

Required Tools and Adhesives

Hex wrench: 2.5mm Thin CA

Phillips screwdriver: #1 Side cutter

Needle nose pliers T-pin

 1. Open the bag containing the tail wheel assembly and

accessories. The fuselage assembly will also be required for

this section of the manual.